Sharp PN-86HC1 Operation Manual page 13

6. LAN terminal
• When Power Save Mode is Off, you can use "Wake on
LAN (Magic Packet)" to turn on the power via LAN.
7. TOUCH PANEL terminal 2 (for touch panel)
• To use the touch panel with a computer, connect the
touch panel to the computer with a USB cable.
• To use this terminal, connect your computer to the video
input terminal on the rear of the monitor.
8. RS-232C input terminal
• You can control the monitor from a computer by
connecting a commercially available RS-232 straight
cable between these terminals and the computer. The
terminal on the monitor is a female-type connector.
9. Audio output terminal
• The output sound varies depending on the input mode.
• You can adjust the volume from the speakers of this
monitor and the audio output terminal simultaneously by
using VOLUME.
• When a cable is connected to the audio output terminal,
audio is not output from the monitor speaker.
• Bass, Treble, and Balance cannot be adjusted on audio
that is output from the audio output terminal.
10. Audio input terminal
• Use an audio cable without resistance.
11. D-sub input terminal (VGA)
12. Digital audio output (optical) terminal
• Audio that is input into the monitor is output.
• Connect using a commercially available audio digital
cable.
• The output sound varies depending on the input mode.
• You can adjust the volume with volume adjustment.
13. Mini AV input terminal
• Change the input mode to AV.
• A conversion cable must be purchased separately.
14. Mini Component input terminal (YPBPR)
• Change the input mode to YPBPR.
• A conversion cable must be purchased separately.
How to remove a USB flash drive
1. Start File Explorer. (See page 24.)
2. Touch
Video
Audio (L)
Audio (R)
Y
Pb/Cb
Pr/Cr
Connecting Peripheral Equipment
of the device you want to unmount.
13
E