Connecting The Power Cord; Remote Control Battery Installation; Ntsc/Pal Settings - Yamaha DVD-S510 Owner's Manual

16 PREPARATION

Connecting the power cord

After completing all connections, connect the AC power cord to an AC
power outlet
Note: When the player is in the "STANDBY" mode, it is still consuming some power.
If you wish to disconnect your player completely from the power, press the POWER
button.
Caution: Only qualified service personnel should remove the cover
or attempt to service this device.

Remote control battery installation

Loading the batteries
1
Open the battery compartment cover.
2
Insert batteries as indicated inside the battery compartment.
3
Close the cover.
Caution: Do not mix old and new batteries. Never mix
different types of batteries (standard, alkaline, etc.).

NTSC/PAL Settings

You can switch the NTSC/PAL setting of the DVD player to match the video
signal of your TV. This setting only affects the television's on-screen display
that shows the stop and setup modes. You may select either NTSC or PAL. To
change the DVD player setting to PAL or NTSC, follow the steps below.
1
Press the POWER button on the front panel of the DVD player to turn
off the DVD player.
Press and hold 9 and ^/T on the front of the DVD player. While
2
holding 9 and ^/T , press the POWER button.
3
After PAL or NTSC appears on the display panel of the DVD player,
release 9 and ^/T at the same time. The PAL or NTSC that appears
on the display panel indicates the current setting.
To change the setting, press ^/T within three seconds. The new
4
setting (PAL or NTSC) will appear on the display panel.