Yamaha EM-202VCD Owner's Manual page 35

TUNING OPERATION
VIDEO CD
Version 2.0 / Playback Control
DISC
1 2 3
POWER
PHONES
VCD/CD
1 2
1 2
6 7
6 7
A B
TIME PROG
MODE INDEX
DISC SKIP PREV NEXT
LEVEL
CENTER/REAR
TEST FLAT
/DELAY ECHO/
KEY
MUSIC PROGRAM USER
POWER
SLEEP
VOLUME
Memory back-up
The memory back-up circuit prevents the programmed
data from being lost even if the AC supply lead is
disconnected from the AC outlet or the power is cut due
to temporary power failure. If, however, the power is cut
for more than one week, the memory may be erased. If
so, it can be re-programmed by simply following the
Preset tuning steps.
1 2
INPUT SELECTOR VOLUME
VCR/LD-TV/VCD-CD/TUNER/TAPE•MD/AUX
OPEN/
CLOSE
DISC
CHANGE
RANDOM REPEAT TIME MEMORY AUTO/MAN'L
PROGRAM
HOUR MIN TIME ADJ TIMER
PRESET/TUNING/BAND A/B/C/D/E
MUSIC
ECHO ECHO
MIC MIC MIXING
USER MEMORY DISPLAY
MIN MAX
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
I0
OPEN/CLOSE TUNER
1
RETURN SELECT
INPUT
TIME INDEX
INTRO DIGEST
DISPLAY
Automatic preset tuning
You can also make use of an automatic preset tuning
function. By this function, this unit performs automatic tuning
and stores stations with strong signals sequentially. Up to 40
stations are stored automatically in the same way as in the
manual preset tuning method on the previous page.
1
Select the tuner by turning the INPUT SELECTOR until
"TUNER" appears on the display.
2
Press and hold the tuner MEMORY button for about 2
seconds.
* The MEMORY and AUTO indicators will flash.
This unit performs automatic tuning and searches FM and
AM stations in that order. Received stations are programmed
to A1, A2 ... A8 sequentially.
When the automatic preset tuning is completed
The display shows the frequencies of the first preset station
(stored to A1).
Check the contents and the number of preset stations by
following the procedure of the section "To recall a preset
station" on the previous page.
To recall a preset station
Simply follow the procedure of the section "To recall a preset
station" on the previous page.
Notes
•
The automatic preset tuning search will be performed
through all frequencies until 40 stations are stored. If the
number of received stations is less than 40, the search will
stop after searching all frequencies.
* Since FM stations are searched for first, there may be a
case that 40 preset stations are occupied by FM
stations only.
•
With this function, only stations with sufficient signal
strength are stored automatically. If the station you want
to program is weak in signal strength, tune in to it with the
Manual tuning method (in monaural) and program it by
following the procedure of the section "To store stations"
on the previous page.
•
You can replace a preset station by another FM or AM
station manually by simply following the procedure of the
section "To store stations" on the previous page.
E-27