Trim Meter (Digital Type); Hour Meter (Digital Type) - Yamaha F200 Owner's Manual

Basic components
NOTE:
The speedometer displays km/h, mph, or
knots, according to operator preference. Se-
lect the desired unit of measurement by set-
ting the selector switch on the back of the
gauge. See the illustration for settings.
1. Cap
2. Selector switch (for speed unit)
3. Selector switch (for fuel sensor)
EMU26620

Trim meter (digital type)

This meter shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best for
G
your boat under different conditions. Adjust
the trim angle to the desired using the pow-
er trim and tilt switch.
If the trim angle of your motor exceeds the
G
trim operating range, the top segment on
the trim meter display will blink.
22
EMU26650

Hour meter (digital type)

This meter shows the number of hours the en-
gine has been run. It can be set to show the
total number of hours or the number of hours
for the current trip. The display can also be
turned on and off.
Changing the display format
G
Pressing the "
es the display format in the following pat-
tern:
Total hours→Trip hours→Display off
Resetting the trip hours
G
Simultaneously pressing the "
" " (mode) buttons for more than 1 sec-
ond while the trip hours are displayed re-
sets the trip counter to 0 (zero).
NOTE:
The total number of hours the engine has
been run cannot be reset.
ZMU01740
ZMU01741
" (mode) button chang-
" (set) and