Trim Meter (Digital Type); Hour Meter (Digital Type); Warning System; Overheat Warning - Yamaha 90 Owner's Manual

NOTE:
Memorize the trim angles that work best for
your boat under different conditions. Adjust
the trim angle to the desired setting with the
power trim and tilt switch.
EMU26620

Trim meter (digital type)

This meter shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best
G
for your boat under different conditions.
Adjust the trim angle to the desired using
the power trim and tilt switch.
If the trim angle of your motor exceeds the
G
trim operating range, the top segment on
the trim meter display will blink.
EMU26650

Hour meter (digital type)

This meter shows the number of hours the
engine has been run. It can be set to show
the total number of hours or the number of
hours for the current trip. The display can
also be turned on and off.
ZMU04581
Changing the display format
G
Pressing the "
G
es the display format in the following pat-
tern:
Total hours→Trip hours→Display off
G
Resetting the trip hours
G
Simultaneously pressing the "
G
and "
1 second while the trip hours are displayed
resets the trip counter to 0 (zero).
NOTE:
The total number of hours the engine has
been run cannot be reset.
EMU26801
ECM00090
CAUTION:
Do not continue to operate the engine if a
warning device has activated. Consult
your Yamaha dealer if the problem can-
not be located and corrected.
EMU26814

Overheat warning

ZMU01869
This engine has an overheat warning device.
If the engine temperature rises too high, the
warning device will activate.
Basic components
" (mode) button chang-
" (mode) buttons for more than

Warning system

ZMU01870
" (set)
20