Displaying Information; To Display The Format Specification - HP E2470A Manual

Displaying Information

This section describes how to display analyzer configuration information,
state and timing data captured by the preprocessor interface, and symbol
information that has been set up by the preprocessor interface configuration
software.

To display the format specification

•
Select the format specification menu for your logic analyzer.
The configuration files contain predefined format specifications. These
format specifications include all labels for monitoring the microcontroller and
any coprocessors connected directly to the microcontroller.
The figure below shows the Format specification for state analysis. The
figure on the following page shows the Format specification for timing
analysis.
Chapter 3 of this guide contains a table that lists the signals for the
MC68HC16Y1 processor and on which pod and probe bit the signal comes
into the logic analyzer. Refer to this table and to the logic analyzer
connection information for your analyzer in chapter 1 to determine where the
processor signals should be on the format specification screen.
Figure 5
2–3