Switching The Athena On - Barco Athena Installation Manual

Hide thumbs Also See for Athena:
Table of Contents

Advertisement

Starting up

10.1 Switching the Athena ON

How to switch on?
1.
Ensure that the projector is installed onto a stable platform.
2.
Ensure the projector is correctly connected to the mains power.
3.
Ensure that the lamp and lamp house are correctly installed.
4.
Ensure that the correct lens is installed for your application.
5.
Check if a video source is connected to the projector.
6.
Press the Power Switch to switch the projector ON. As a result the projector starts up and the communicator
touch panel starts its initialization procedure.
Note: The projector always boots up in the same mode (E.g. Standby or Sleep) as it was switched off.
This procedure assumes that the projector was switched off in standby mode (projector fully
operational but lamp is off).
7.
Wait until the status light of the projector lights up GREEN (not flashing).
8.
Press the STANDBY button on the Local Keypad or use the Communicator to activate the lamp.
9.
Press the DOWSER button on the Local Keypad or use the Communicator to open the dowser.
Image 10-1
How to awake the projector from Sleep mode?
1.
Press the SLEEP button on the Local Keypad for three seconds or use the Communicator to put the projector
in Standby mode.
As a result the projector starts booting and initializing all electronics. During the booting and initializing phase
the backlight color of the Sleep button is purple (transition phase). Once the projector is fully awake the
backlight color of the Sleep button is green.
Note: When the projector is in Sleep mode only the backlight of the Sleep button lights up red. The
backlight of all other buttons of the Local Keypad remains off.
The backlight color of the Sleep button, Standby button, Dowser button and Test Pattern button
must all light up green to project the image of the applied source.
CAUTION: See user's guide of the Communicator Touch Panel to operate and control the Athena.
When for any reason a restart of the projector is required, the content server should be restarted
also.
98
R5906790 /04
Athena
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dp2k-6eR9008100

Table of Contents