Trane BAYUVCLK001 Installer's Manual page 5

Right Side UV Lamp bracket installation
STEP 1. Remove coil panel. See the air handler Installer's Guide
for additional information if needed.
STEP 2. Cut the cable tie from the right side lamp bracket as-
sembly. Slide the lamp and reflector assembly out of the
bracket as shown.
STEP 3. Measure 7.5 inches above the cross bar and make
a mark on the inside of the air handler cabinet (use a
screwdriver or other metal object to scribe line).
STEP 4. Draw a level line to the back of the air handler
cabinet. This line will be used as a guide for the proper
placement of the lamp bracket. The bottom of the lamp
bracket will line up with the scribe line.
18-GJ11D1-2
End View
7.5"
Cross Bar
5