SRAM RockShox Vivid Air Series Technical Manual page 23

102. Clamp the shock back into the vise at the body
eyelet. Install the IFP reservoir cap onto the IFP
reservoir and thread it by hand until the o-ring
contacts the reservoir housing. Use the 2011
SRAM 24 mm pin spanner tool to tighten the seal
head to 11.2 N·m (100 in-lb).
The torque wrench should be attached at a
90° angle to the 2011 SRAM 24 mm pin spanner
tool in order to obtain an accurate torque
measurement.
103. Use a Schrader valve tool to install a
core into the reservoir cap. Thread the core into
the cap. Tighten the valve core to 1.1 N·m
(10 in-lb)
104. Install the SRAM Vivid air pump adapter onto
a gauged shock pump and pressurize the IFP
chamber to:
Shock Model
Vivid Air R2C
Vivid Air R2
once you have pressurized the shock, remove
the SRAM vivid air pump adapter from the air fill
port bEfoRE removing it from the shock pump.
Separating the pump from the adapter first will
allow all of the air to escape from the shock.
105. Use a pick to remove and replace the IFP
reservoir air cap o-ring.
106. Use a T10 TORX wrench to install the IFP
®
reservoir air cap.
107. Spray the entire shock with isopropyl alcohol
and wipe it with a clean rag.
Clean all oil out of the air can seal head threads.
23
SERviCE inSTRuCTionS (ConTinuEd)
102
new valve
103
pressure
200 psi (13.8 bar)
230 psi (15.9 bar)
105
104
106
GEN.0000000003161 REV A