Updating The Firmware - QTS AN-X2-ABDHRIO User Manual

The AN-X2 operating software consists of the maintenance firmware and the runtime
firmware.
The maintenance firmware runs at startup. It performs diagnostics, updates any
firmware that has been downloaded, and starts the runtime firmware.
The firmware files are supplied in files that begin with AN-X2 and have extension qtf .
They are updated using the web interface. Run the command Administration/Update AN-
X Firmware and select the file you wish to download.
Do not download firmware to the AN-X while applications that use the
WARNING!
AN-X are running.
The web page displays the download progress at the bottom left of the page.
You must restart the AN-X2 to run the firmware that you downloaded.
It is essential that you do not disrupt power while downloading
firmware, especially maintenance firmware, to the AN-X2 or while the
AN-X2 is restarting following a firmware download.
WARNING!
Interrupting power at some points in the update process could render the
AN-X inoperative and it would have to be returned to the factory for
reinitialization.
The web interface displays the version of the firmware the AN-X2 is running on the tab
at the top of the page.
You can also update the firmware by copying qtf files to the microSD card from a
computer. If you do, make sure that there is only one version of each qtf file on the
microSD card.
AN-X2-ABDHRIO Remote I/O Drive Interface Page

Updating the Firmware

41