Ethernet Cabling; Software Installation - QTS AN-X2-ABDHRIO User Manual

Ethernet Cabling

AN-X has a standard RJ-45 connector for connecting to Ethernet.
If you are connecting to the AN-X through a router or switch, use a standard Ethernet
cable.
If you are connecting directly to the AN-X module, use a crossover cable.

Software Installation

There is no required software installation for the AN-X2-ABDHRIO-DRV. All
configuration can be done using the web interface.
CE Installations
If you are installing the AN-X2 in a location which requires CE, install the following
ferrites or their equivalents on the cables:
Steward 28A2024-0A2 on Ethernet cable close to module, one loop
Steward 28A2024-0A2 on power cable
Steward 28A2025-0A2 on DH+/RIO Cable
AN-X2-ABDHRIO Remote I/O Drive Interface Page
7