Before You Begin - Razor RSF350 Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during
shipping. Because the RSF350 is 95 percent assembled and packed at the factory, there should not be any problems,
even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 15 minutes for assembly.
Allow up to 12 hours for initial charge (see page 6 for charging information).
Brake Lever
Front Fork
Charger Port
Required Tool
6 mm Allen Wrench
(Included)
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
2.
Chain Guard
1.
Throttle
ON/OFF Switch
3.
3
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
RSF350. The RSF350 has been
built to certain Razor design
specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may not be
compatible and will void
your warranty.
Product ID Locations:
(See locations to the left)
1. Charger
2. Underneath Frame
3. Battery Cover
4. UPC Side of Box (not shown)
Plastic Bag Contents:
• Charger
• Tool
• Handlebar Clamps
• Owner's Manual