Table of Contents
Advertisement
Lubrication Points
1. Lubricate the following with Quicksilver or Mercury Precision
2‑4‑C with PTFE.
Tube
Ref No.
95
IMPORTANT: It is important not to use a general all‑purpose
grease for this bearing. The lubricant recommended is a
water‑resistant grease of the proper consistency for this
application. If a substitute is used, be sure that it is
water‑resistant.
• Driveshaft bearing
i. Pull vent hose off of the grease fitting.
ii. Pump in grease through the grease fitting until
iii. Reconnect the vent hose onto the grease fitting
NOTE: After 30 hours of operation, pump in extra grease to
purge out any moisture. Visually inspecting the purged grease
at this time will give an indication of conditions inside the
bearing housing. A gradual increase in moisture content
indicates seal wear. If the grease begins to turn a dark, dirty
gray color, the driveshaft bearing and seals should be inspected
and replaced if necessary. Some discoloration of the grease is
normal during the break‑in period on a new set of seals.
2. Lubricate the following with Quicksilver or Mercury Precision
Special Lubricant 101.
eng
MAINTENANCE
Description
2-4-C with
PTFE
excess grease starts to exit the vent hose.
after greasing.
b
a
Where Used
Driveshaft bearing
a -
Grease fitting
b -
Vent hose
28691
75
Part No.
92-802859A 1
Advertisement
Table of Contents
