Cleaner Description - Hoover BRUSH N WASH Instructions Manual

How to use

Cleaner description

1
15
3
2
5
9
10
11
12
13
15
16
24
21
16
A
B
ON/OFF pedal &
Handle release pedal
Step on pedal (A) to turn cleaner
16
on. Step on pedal again to turn
cleaner off.
Step on pedal (B) to lower handle to
operating position. Handle does not lock
into a single position but "floats" to allow
convenient operation.
6
7
8
5
6
4
14
17
18
19
23
7
20
17
Automatic "shut off"
nism will shut off the cleaner suction (suc- 17
tion will be noticeably reduced).
At that time the red or yellow float disk
will rise to the top of the recovery tank
up dirty solution and the motor sound
lid (C). The cleaner will no longer pick
will become noticeably higher in
pitch.
When this happens, turn cleaner off
and empty recovery tank before con-
tinuing use.
Check clean solution tank also; it may
need to be refilled.
The assembled cleaner will look like the drawing.
1. Hand grip
2. Solution trigger: press to
3. Clean Surge™ button
release clean solution.
4. Cord clip: place cord in
clip to keep it out of the
5. Hose
way when using cleaner
6. Hose holder: wrap hose
around holder and hooks
7. Hose hooks
for storage.
8. Cord hooks: wrap cord
around hooks for storage.
The top hook can be rotat-
8
ed right or left for quick
9. Stair/upholstery nozzle
and easy cord release.
10. Carrying handle
11. Clean solution tank
handle
22
12. Clean solution tank cap/
measuring cup
13. Clean solution tank:
14. Recovery tank lid
holds cleaning solution.
15. Recovery tank: holds
dirty solution.
When the recovery tank (lower tank)
is full, the automatic shutoff mecha-
16. Recovery tank front
panel
17. Hood
18. Brush speed selector:
slide selector to set brush
19. Brush Indicator: spins
speed on HI, LO, or OFF.
20. Nozzle
when brushes are rotating.
21. Solution tube connection
22. Recovery tank latches
23. ON/OFF pedal
24. Handle release pedal:
step on pedal to lower
handle to operating (floor)
position.
This carpet cleaner is intend-
ed for household use.
Operate carpet cleaner only
at voltage specified on data
plate on back of cleaner.
Plug carpet cleaner Into a
properly grounded outlet.
C
18
Turn cleaner off before trans-
To transport
porting.
18
To move your cleaner from room to
room, put handle in upright and locked
position, tilt cleaner back on wheels and
push forward.