Table of Contents
Advertisement
Recommended cutting equipment for
USA
Following is a list of recommended cutting equipment for
Husqvarna 330i and 535i XP. This model equipped with
either of the listed guide bar and saw chain
combination(s), fulfills the requirements according to UL
60745-1 and UL 60745-2-13.
Chainsaw models Husqvarna 330i and 535i XP met the
kickback performance requirements of UL 60745-2-13
when tested with the combinations of bars and saw
chains listed below. The saw chain Husqvarna H38 is
also classified as a low kickback saw chain since is met
the requirements for low kickback saw chain outlined in
UL 60745-2-13. We recommend to use only the listed
combinations of bars and saw chains for chainsaw
models Husqvarna 330i and 535i XP. Other chainsaw
models may not meet the kickback requirements when
equipped with the listed bar and saw chain
combinations.
Guide bar and saw chain combinations
Following is a list of recommended cutting equipment for
Husqvarna 330i and 535i XP. The listed combination(s)
Guide bar
Length, in
Chain pitch, in
10
3/8
12
14
10
0.325 mini
12
14
Filing equipment and filing angles
Using Husqvarna file gauge will give you the correct
filing angles. We recommend you to always use a
Husqvarna file gauge to restore the sharpness of the
34
Accessories
of powerhead, guide bar and saw chain meet all
requirements outlined in Canadian Standards
Association Z62.1-11 (Chain saws) and Z62.3-11 (Chain
Saw Kickback).
Furthermore the saw chain Husqvarna H38 is evaluated
and listed as a Type C Low Kickback Saw chain
according to the provisions in Z62.3-11.
Kickback information
The guide bar nose radius is determined by either the
maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius,
you may use a guide bar with smaller nose radius than
in our list. For guide bars of the same length, all
sprocket-nose guide bars of the same pitch and having
the same number of sprocket teeth may be considered
to have equivalent kickback energy.
The following cutting equipment is approved for the
models Husqvarna 330i and 535i XP.
Gauge, in
Max. nose radius
0.043
7T
9T
0.043
8T
saw chain. The part numbers are given in the table
below.
If you do not know which saw chain you have on your
product, turn to your servicing dealer.
Saw chain
Type
Length, drive
links (no.)
Husqvarna H38
40
45
52
Husqvarna
46
SP21G
51
59
958 - 010 - 24.04.2020
Advertisement
Table of Contents
