Table of Contents
Advertisement
A
RIGHT
OFFSET
R
L
L
CD4990
L
Figure 8. Front Caster Arm Configuration for
RD6000-2 & RD7200-2 Only
FRONT CASTER WHEEL INTERFERENCE
CHECK
IMPORTANT
■
Do not operate tractor and mower until this
interference check has been performed. If you
change tractors, you must perform the check for
that mounting.
Perform this check with all of the spacers and springs
above the caster wheel arm. This will place the caster
MAN0180 (Rev. 1/7/2005)
B
R - Right Offset
L - Left Offset
A - Mounting Holes
B - Pivot Tube
R
R
R
wheels in their highest position and provide the lowest
cutting height for the mower.
1. Raise mower with tractor hydraulics to 16" at
dimension C or maximum height of tractor lift,
whichever is less.
2. Pivot both front caster wheels forward and check
that there is clearance between caster wheels and
L
tractor tires.
3. If there is interference on models RD6000-2 and
RD7200-2, mount front casters in the outer
position.
NOTE: On model RD8400-2, caster wheel width is not
adjustable; see tractor operator's manual and adjust
tractor wheels to narrower spacing.
CD3528C
Figure 9. Front Gauge Wheel Interference Check
FRONT ROLLER (OPTIONAL)
The caster wheels and side skids effectively reduce
scalping in most cases. However, you may encounter
areas where the caster wheels and/or side skids drop
into depressions and allow center of the mower to con-
tact ground and scalp. An optional front roller may be
installed to minimize scalping.
OPERATING TECHNIQUE
Stop power unit and implement immediately
upon striking an obstruction. Dismount power unit,
using proper procedure. Inspect and repair any
damage before resuming operation.
Power for operating mower is supplied by tractor PTO.
Operate PTO at 540 rpm. Know how to stop tractor and
mower quickly in an emergency.
CAUTION
Operation 11
C
Hide quick links:
Advertisement
Table of Contents
