Substrate Fastener Recommendations - B&D Roll-A-Door 2 Series Installation Instructions Manual

Roll-A-Door Series 2 installation instructions
®

1.2 substrate fastener recommendations

WARNING! Coach bolts/
screws supplied are NOT
suitable for windrated
doors. Refer to DTCM
drawings.
WARNING! The installer
must select and use
fasteners appropriate to
the material into which
they are being fixed.
important notes
a) For installation to materials
not covered in the chart,
the installer should seek
expert advice from
qualified builder.
b) Minimum length of fastener
does not exclude use of
longer lengths. Decision
must be made by fitter to
ensure adequate strength.
c) Recommendations for old
materials or materials not
in good condition are not
included. If in doubt about
the strength of the material
seek specialist advice.
d) Fasteners for brackets in
masonry should be at least
5/16" x 2.5" long or metric
equivalent.
BRICK
CONSTRUCTION
masonry
anchors
(minimum
bolt size
10mm
/ ")
3
8
MASONRY BLOCK
CONSTRUCTION
long bolts
steel plate
Fig: 2.1.1
material
New Solid Brick
Macplugs (wall plugs) to suit
HLC Sleeve Anchors (Dyna Bolts)
HRD-VGK
New Hollow Brick
New Solid Concrete
Macplugs (wall plugs) to suit
a
HLC Sleeve Anchors (Dyna Bolts)
Steel Framing
e.g. BHP Framing
(with rear access)
Heavy Gauge Steel
Light Steel Framing
e.g. BHP House
Framing
(no rear access)
New Timber
STEEL CONSTRUCTION
weld
left hand
bracket
WARNING! Masonry blockwork should be properly filled and
reinforced if brackets are to be mounted directly to blockwork
with masonry anchors. Where the blockwork is not solidly filled
but structurally sound, long bolts should be passed through the
blockwork using suitable steel plates under bolt heads.
Special consideration should be given to brick type and
construction of wall, to ensure satisfactory fixing e.g. welding
detail if fixed to steel.
right hand
bracket
fastener type(s)
Coach Bolts (Hex Lag Screw)
- combined with wall plugs
above
or HGK-VGS (Hex
Head) Frame Anchors
Coach Bolts (Hex Lag Screw)
- combined with wall plugs
above
Hex Head Bolt Zinc Plated,
Hexagon Nuts Zinc Plated,
Washers Zinc Plated
Hex Head Tek
Heavy Duty Kap Toggle
Hex Head Tek
Coach Bolts (Hex Lag Screw)
Hex Head Tek
right
hand
bracket
bolt
guides
to steel
work
length of
diameter
fastener
or type
(see note)
5/16" x 1½"
3/8" x 2"
5/16" x 50mm
3/8" x 60mm
12mm x 55mm
10mm x 60mm
5/16" x 1½"
3/8" x 2"
5/16" x 50mm
3/8" x 60mm
12mm x 55mm
5/16" x 1"
3/8" x 1"
10mm x 25mm
12mm x 25mm
14-20 x 22mm
10mm x 100mm
12mm x 100mm
6-10 x 20mm
5/16" x 1½"
3/8" x 2"
14-10 x 50mm
SECURE GUIDE
coach
screws
into
masonry
plugs
4
BKT GUIDE
•
• •
•
• •
•
• •
•
• •
•
• •
•
•
• •
• •
•
• •
• •
•
•
•
• •
• •