Centre Locking Bar - B&D Roll-A-Door 2 Series Installation Instructions Manual

Roll-A-Door Series 2 installation instructions
®
2.6.2 centre locking bar (R2W & R2L)
NOTE: Refer to appendix for additonal lock options
available.
LACERATION: Wear appropriate gloves as
some edges of the door are very sharp.
a) Raise the curtain until the lock corrugation is visible above
the door guides.
b) Install locking bar retainer
by pushing retainer towards door edge, sliding the legs
under the Nylofelt ® and hooking them over the curtain
edge. Ensure lock bar retainers sit squarely on door
curtain (Fig 2.6.3).
It is easier to hook legs one at a time.
tip
c) Fit faceplate F to outside of door where the hook will
latch onto curtain edge, then slide faceplate as far to the
right as possible. Use adhesive tape on outside to hold in
position (Fig 2.6.4).
d) Attach the lock body F
using the mounting screws and washers. Do not over
tighten the screws (Fig 2.6.5).
e) With the door in the closed position slide the end of the
locking bars through the locking bar retainers, and while
holding the bars level mark the side of the guides.
f) Drill and file out a rectangular slot no longer than 25mm
and no wider than 10mm. Ensure top of slot remains in line
with top of locking bar (Fig 2.6.6).
g) Slide bars D through the guide slot, then back onto lock
arms. Screw on securely using the counter sunk screws.
Ensure that locking bars do not protrude more than 20mm
beyond guide when engaged in locked position. It may
be necessary to adjust the length of the bars.
h) Ensure a clean and dry guide surface. Wipe guide with
clean rag.
i) Peel off lining from lock bar cover
hole. Check that the movement of the locking bar is free.
LOCK BAR COVER
LOCK BAR COVER
DOUBLE SIDED
ADHESIVE TAPE
DOUBLE SIDED
ADHESIVE TAPE
CUT-
LOCK BAR COVER
Fig: 2.6.6
LOCK BAR COVER
WARNING! Locking bar covers must be installed to
prevent possible finger entrapment.
I in line with lock corrugation
to the faceplate from the inside,
H
and position over
CUT-
H
NYLOFELT
Fig: 2.6.3
LOCK CORRUGATION
LOCK CORRUGATION
LOCK CORRUGATION
Fig: 2.6.4
FACEPLATE
FACEPLATE
LOCK ASSEMBLY
Fig: 2.6.5
12
LEGS
I
LEGS
NYLOFELT
LEGS GO UNDER
NYLOFELT AND
SNAP OVER
CURTAIN EDGE
LEGS GO UNDER
NYLOFELT AND
SNAP OVER
CURTAIN EDGE
THIS END FIRST
THIS END FIRST
THIS END FIRST
HOOK
HOOK
F
F
LOCK ASSEMBLY
HO