Before You Start; Installation Safety Warnings - B&D Roll-A-Door 2 Series Installation Instructions Manual

Roll-A-Door Series 2 installation instructions
®

1.0 before you start

1.1 installation safety warnings

This B&D Roll-A-Door is designed and tested to provide security, attractive appearance and smooth ,
low effort operation provided it is installed and operated in strict accordance with the following safety
warnings. Failure to comply with the following instructions may result in death, serious personal injury
or property damage.
NOTE: No guarantee will be given or responsibility accepted by the manufacturers if the door is not
installed as instructed.
WARNING!
Crush injury from
unsecured door
Tension Springs
ELECTROCUTION!
LACERATION:
CAUTION:
Muscular strain
Fall from ladder
Hand Tools
Entanglement
TWO PERSON LIFT:
• Place a 2 metre exclusion zone around area under the garage opening
while installing door. If sufficient area is not available DO NOT install door.
• Do not move under a door while it is on the door support (or lifting device).
• Follow the installation instructions.
• Fit door support (or lifting device) snugly under door before lifting.
• Ensure door support (or lifting device) is on flat ground.
• Ensure the door is immediately fastened to the bracket with the "U" Bolt.
• Ensure no-one walks under a door sitting on brackets.
• Ensure door is correctly secured at all times when making adjustments.
• Ensure the correct length pipe wrench is utilised.
• Ensure that pipe wrench is fitted correctly to the axle and if it is gripped onto
the axle do not underestimate the tension in the spring when undoing the
clamps
.
• Ensure correct bolts are tightened or loosened to ensure there is no release
or controlled release of energy from the spring through the pipe wrench.
• Keep head clear of the pipe wrench at all times.
• Check risk assessment for any highlighted electrical power concerns.
• Ensure power source is isolated prior to commencement of job.
• Turn off electricity to site when necessary.
• Wear rubber soled footwear.
• Wear appropriate PPE (Dyneema cut off gloves) and keep hands well clear
of pinch points.
• Follow instructions explicitly, particularly for the installation of some parts
of the doors, as the unrolled cut out edges presents a very sharp edge.
• Practice correct lifting techniques when required to lift the door.
• Use mechanical aids such as lifting devices, forklift and cranes where
possible.
• Avoid twisting.
• Use correct technique of knotted rope installation aids.
• Ensure ladder is the correct type for job.
• Ensure ladder is on flat firm ground that will take the weight without the legs
sinking.
• Ensure user has 3 points of contact while on ladder.
• Wear appropriate PPE and utilise operators manual of all tools.
• Use appropriate noise/hearing protection in the form of ear plugs or ear
muffs.
• Ensure appropriate fire protection available and housekeeping to ensure
that flammable liquids or materials are removed from the area of work.
• Keep hands and loose clothing clear of moving door and guides at all
times.
• When a mechanical aid is not used this product requires a two person lift
to raise onto the brackets. Use proper techniques and equipment to lift the
door from the trailer and up onto brackets.
3