Sleep Timer Setting - Philips FW-i1000 Manual

Before setting the timer, make sure the music
source has been prepared.
CD – Load the disc(s). To start from a specific
track, make a program (refer to "CD Operation -
Programming the disc tracks").
TUNER – tune to the desired radio station.
TAPE – load the prerecorded tape into tape
deck 2.
CONNECT – select a desired Internet Audio
station.
3
Press à or á on the system repeatedly to set
the hour for the timer to start.
4
Press í or ë on the system repeatedly to set
the minute for the timer to start.
5
Press CLOCK/TIMER to store the start time.
The timer is now set and activated.
will remain on the display.
TIMER
At the preset time, the selected source will play.
To exit without storing the setting
Press Çon the system.
Notes:
– If CD is the selected source and it is not
available when the preset time is reached, Tuner
will be selected automatically.
– If Tape is the selected source, and if the preset
time is reached during high speed dubbing, Tuner
will be selected automatically.
– If Internet Audio is the selected source, and
there is no connection after 30 seconds, Tuner will
be selected automatically.
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
To deactivate the TIMER
Press TIMER ON/OFF on the remote control.
The display will show "CANCEL" and
will disappear from the display.
To activate the TIMER
Press TIMER ON/OFF on the remote control.
The last set timer information will be shown
for a few seconds and
display.
pg 001-036/i1000/37-Eng
TIMER
will appear on the
TIMER
31
Clock/Timer

Sleep Timer Setting

The sleep timer enables the system to switch to
Standby mode automatically within a preset
amount of time.
1
Set the clock (refer to "Clock Setting").
2
Press SLEEP on the remote control repeatedly
to select a preset amount of time.
The selections are as follows (time in
minutes):
60 ™ 45 ™ 30 ™ 15 ™ OFF ™ 60 ...
"SLEEP XX" or "OFF" will be displayed. "XX"
is the time in minutes.
3
When you reach the desired length of time, stop
pressing the SLEEP button.
The Sleep Timer is now set. After this
amount of time passes, the system will switch to
Standby mode.
To deactivate the Sleep Timer
Press SLEEP repeatedly until "OFF" is displayed,
or press the STANDBY ON button.
4/20/01, 8:35 AM
31
3139 115 20831