Disc Playback; Programming The Disc Tracks - Philips FW-i1000 Manual

Disc Playback

To play all discs on the disc tray
Press PLAYÉ Å .
All the available discs will play once, then stop.
During playback, the selected disc tray, track
number and elapsed playing time of the current
track will appear on the display.
To play one disc only
Press DISC 1, DISC 2 or DISC 3.
The selected disc will play once, then stop.
To interrupt playback
Press PAUSEÉ Å .
To resume playback, press PLAYÉ Å again.
To stop playback
Press Ç.
To search for a particular passage during
playback
Press and hold à or á and release it when
the desired passage is located.
During searching, the volume will be reduced.
To select a desired track
Press í or ë repeatedly (or Digits 0–9 on
the remote control) until the desired track
appears on the display.
If playback is stopped, press PLAYÉ Å to start
playback.
Note:
– In Shuffle mode, pressing í will cause the
player to skip only to the beginning of the current
track.
To skip to the beginning of the current
track during playback
Press í once.
Replace discs during playback
1
Press DISC CHANGE.
2
To change the inner disc, press DISC
CHANGE again.
"DISC CHANGE" will be displayed and the
disc will stop playing.
The disc tray will close to retrieve the inner
disc, then reopen with the inner disc accessible.
pg 001-036/i1000/37-Eng

Programming the disc tracks

Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order.
1
Load the desired discs on the disc tray (refer to
"Loading Discs").
2
Press PROG to start programming.
PROGRAM
3
Press CD (CD 1•2•3) or DISC 1/2/3 to select
a disc.
4
Press í or ë (or Digits 0–9 on the remote
control) to select the desired track.
5
Press PROG to store the track.
Repeat steps 3–5 to store other discs and
tracks.
6
Press PLAYÉ Å to start program playback.
"PLAY PROGRAM" will be displayed.
To end programming without starting playback,
pressÇ once .
The total number of tracks programmed and
the total playing time will appear on the display.
Notes:
– If the total playing time is more than "99:59"
or if one of the programmed tracks has a number
greater than 30, then "--:--" will appear on the
display instead of the total playing time.
– If you attempt to program more than 40 tracks,
"PROGRAM FULL" will be displayed.
– If you press any of the DISC 1/2/3 buttons, the
system will play the selected disc or track, and the
stored program will be ignored temporarily. The
PROGRAM
from the display. It will reappear when playback of
the selected disc ends.
– During programming, if no button is pressed
within 20 seconds, the system will exit the Program
mode automatically.
To review the program
Stop playback and press í or ë repeatedly.
To exit review mode, press Ç.
23
CD Operation
will start flashing.
symbol also will disappear temporarily
3139 115 20831
4/20/01, 8:35 AM
23