Install The Server In A Rack; Cable The Server; Power On The Server - Lenovo ThinkSystem SR150 Setup Manual

• Drive bay 2 and 3 are not available when the two-drive backplate is installed.
To install a simple-swap disk drive, complete the following steps:
Note: When the fourth SATA drive is installed, the M.2 drive is not supported.
Figure 46. Simple-swap disk drive installation
Step 1. Slide the drive into the drive bay. Make sure the drive handle is in the open position.
Step 2. Lock the drive into place by rotating the drive handle inward until it clicks.
After you install all simple-swap disk drives, complete the following steps:
1. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
2. Reconnect power cords and all external cables.

Install the server in a rack

To install the server in a rack, follow the instructions that are provided in the Rail Installation Kit for the rails
on which the server will be installed.

Cable the server

Attach all external cables to the server. Typically, you will need to connect the server to a power source, to
the data network, and to storage. In addition, you will need to connect the server to the management
network.
Connect to power
Connect the server to power.
Connect to the network
Connect the server to the network.
Connect to storage
Connect the server to any storage devices.

Power on the server

After the server performs a short self-test (power status LED flashes quickly) when connected to input power,
it enters a standby state (power status LED flashes once per second).
The server can be turned on (power LED on) in any of the following ways:
58
ThinkSystem SR150 Setup Guide