Channel Type Setup - Kenwood ProTalk DIGITAL NX-P1200NV User Manual

Channel Type Setup

Set the Channel Type of the selected Zone-Channel to "Analog", "NXDN" (Digital),
or "Mixed" (Dual). The following is the transceiver behavior for transmission and
reception on a channel with "Mixed" (Dual) configured in Channel Type:
Transmission: The transceiver transmits in the mode (Analog or NXDN)
configured in the TX Setup Mode
Reception: Mixed mode can be used to wait for a call in both Analog (QT tone
and DQT code) and Digital (RAN) modes.
To set the Channel Type
During CHANNEL SETUP, rotate the Selector to select a channel number.
1
• The transceiver announces the zone number and channel number.
Press the Side 1 or Side 2 button to select the Channel Type Setup Mode.
2
• The transceiver announces "Channel Type".
• If the Frequency of the currently selected channel is set to "Off", the
Channel Type Setup Mode cannot be selected.
Press the PTT switch to enter the Channel Type Selection.
3
Press the Side 1 or Side 2 button to select the Channel Type.
4
Channel Type
Analog
NXDN
Mixed
Press the PTT switch to temporary save the selected Channel Type.
5
• Beep B (2 beeps) will sound.
• Repeat steps 1 to 5 to set up another channel.
Press the Side 1 or Side 2 button to select the Confirmation Setup Mode.
6
• The transceiver announces "Confirm".
Press the PTT switch to save the settings and return to the ID SETUP/ ZONE
7
SELECTION.
• Beep B (2 beeps) will sound.
• Turn the transceiver power OFF and then ON return to normal operation
with new settings.
Note:
◆ If no action is performed for 20 seconds, the transceiver will automatically return to
normal operation without changing any settings.
{p. 27}
Voice Announcement
Channel Type Analog
Channel Type Digital
Channel Type Dual
.
Operate in Analog mode.
Operate in Digital mode.
Operate in Analog / Digital Mixed mode.
26
Description