Kenwood ProTalk DIGITAL NX-P1200NV User Manual page 36

To set the functions of the Side 1 and Side 2 buttons
With the transceiver power OFF, press and hold the Side 1 and Side 2 buttons
1
while turning the transceiver power ON.
• Continue to hold the Side 1 and Side 2 buttons until the LED lights yellow
and the transceiver announces "Setup".
Release the button.
2
Press and hold the button to be reprogrammed (either the Side 1 or Side 2
3
button).
• The transceiver will announce "Table 0".
- The selection table number starts from "Table 0", not the current table
number.
Release the button.
4
Press the Side 1 or Side 2 button to increment/ decrement the table number, to
5
select the new button function.
• Table numbers and their corresponding functions are provided in the table
{p. 35}.
• A voice announcement will inform you of the currently selected table
number.
Press the PTT switch to save the settings.
6
• Beep B (2 beeps) will sound and the transceiver will announce the new
table number.
Turn the transceiver power OFF and then ON again to activate the new settings.
7
Note:
◆ If no action is performed for 20 seconds, the transceiver will automatically return to
normal operation without changing any settings.
36