Wolf ICBIS15/S Installation Instructions Manual page 9

W O L F
E L E C T R I C A L
Attach the power cord to the unit before
plugging the cord into the wall.
Required Power Supply
220–240 V AC, 50 Hz, 15 amp service
Maximum Connected Load
2.6 kW
The Wolf electric steamer module requires a
separate, grounded 3-wire 220–240 V AC,
50 /60 Hz, 15 amp service with its own circuit
breaker or fuse. A properly rated cord should
be attached to the power supply box of the
steamer as shown in the illustration below.
Open the power box to expose the screws with
corresponding numbers. Loosen the 1, 5, and
ground screws. Run the cord through the
circular hole and into the power supply box.
Attach the Neutral wire to the number 1
position. Line should be attached to the 5
position and attach the ground to the corre-
sponding ground screw. After tightening the
screws, close the cover to the power supply
box without pinching any of the wires.
10
S T E A M E R M O D U L E
R E Q U I R E M E N T S
You must follow local codes and ordinances
when installing your service.
IMPORTANT NOTE: The correct voltage,
frequency and amperage must be supplied to
the appliance from a dedicated, grounded
circuit which is protected by a properly sized
circuit breaker or time delay fuse. The proper
voltage, frequency, and amperage ratings are
listed on the product rating plate located on
the underside of the module. Refer to the illus-
tration on page 5.
The wiring diagram covering the control circuit
is located inside the module control box.
The complete appliance must be properly
grounded at all times when electrical
power is applied.
Improper connection can result in a fire
hazard!
IMPORTANT NOTE: To avoid electrical shock
when disconnecting the steamer module, all
poles/wires must be disconnected from the
power supply box.
Power supply box