Wolf IS15/S Installation Instructions Manual
Steamer module
Hide thumbs
Also See for IS15/S:
- Use & care manual (24 pages) ,
- Installation manual (12 pages) ,
- Planning information (6 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Wolf IS15/S
Summary of Contents for Wolf IS15/S
- Page 1 T E A M E R O D U L E NSTALLATION NSTRUCTIONS...
- Page 2 800-332-9513 Website: wolfappliance.com ® WOLF is a registered trademark of Wolf Appliance Company, LLC As you follow these instructions, you will notice WARNING and CAUTION symbols. This blocked information is important for the safe and efficient installation of Wolf equip- ment.
- Page 3 IMPORTANT NOTE: Installation and service must be performed by a qualified installer or service agency. Warranty service must be performed by a Wolf authorized service center. Installation of the steamer module must meet the minimum clearance requirements for safe operation. Refer to Site Preparation on page 4.
- Page 4 S T E A M E R M O D U L E S I T E P R E P A R A T I O N IMPORTANT NOTE: Installation of the Wolf electric steamer module must meet the follow- ing location requirements. All dimensions listed are minimum requirements for safe operation.
- Page 5 S P E C I F I C A T I O N S The illustrations below provide the overall dimensions, finished cut-out dimensions and electrical placement for the Wolf electric steamer module. The steamer module is designed to fit a standard 24"...
- Page 6 IMPORTANT NOTE: Review specific installation instructions for product to product capabilities. This steamer module must be installed at least 15" (381) away from a Wolf fryer module, as contact between water and hot oil may cause burns from steam and hot oil. "...
- Page 7 O P T I O N S IMPORTANT NOTE: It is recommended that you operate the Wolf electric steamer module with either a Wolf cooktop or Pro ventilation hood or hood liner. Contact your Wolf dealer for details. Cooktop Wall Hood – 30" (762) or 36" (914) widths in classic stainless steel.
- Page 8 Maximum Connected Load 2.6 kW at 240 V AC 1.9 kW at 208 V AC The Wolf electric steamer module requires a separate, grounded 3-wire 240/208 V AC, 60 Hz, 15 amp service with its own circuit breaker. The module is provided with a 4' (1.2 m) flexible 3-wire conduit that makes a connection to a junction box.
- Page 9 Foam strip B E F O R E O P E R A T I N G Read the entire Wolf Steamer Module Use & Care Information included with the module. Important safety, service and warranty information is contained within the book.
- Page 10 M O D U L E R E M OVA L IMPORTANT NOTE: Removal of the steamer module should only be performed by a Wolf authorized service center technician. If removing the steamer module is necessary for cleaning or service, first disconnect the electric supply.
- Page 11 Neither this book nor any information or images contained herein may be copied or used in whole or in part without the express written permission of Wolf Appliance Company, LLC, an affiliate of Sub-Zero Freezer Company, Inc. ©Wolf Appliance Company, LLC all rights reserved.
- Page 12 W O L F A P P L I A N C E C O M PA N Y, L L C P. O. B OX 4 4 8 4 8 M A D I S O N , W I 5 3 7 4 4 8 0 0 - 3 3 2 - 9 5 1 3 W O L FA P P L I A N C E .