Lenoxx BT9350 Instructions Manual page 6

3. Numerical buttons: When the FM radio stations have been scanned in to the speaker, press the
numerical buttons to go to a saved radio station position.
4. Lights: Press for all lights to be on or off.
5. LED: Press to change the mode of the lights displayed.
6. Vol +: Press to increase the volume level.
7. Prev/CH -: Press to play the previous music track or previous radio station.
8. Next/CH+: Press to play the next music track or next radio station
9. Vol –: Press to decrease the volume level
10. Play/Pause/scan: Press to pause playback of a music track. Press again to resume playback of a
music track.
To program radio stations, press the scan button when the speaker is on radio mode. The
speaker will then scan and save the available radio stations into
pre-set memory positions.
11. Mode: Press repeatedly to change the playback mode on the speaker.
12. EQ: Press repeatedly to change the equaliser mode on the speaker during music playback.
13. Light flash: Press to change the light mode for the stage light. Press repeatedly to change
between blinking, scrolling or off.
14. MD: Press to repeatedly change the scrolling mode of the stage light.
15. M.V – and M. V+: Microphone volume adjustment. Press M.V – to decrease microphone
volume, press M.V+ to increase microphone volume.
16. Echo – and Echo+: Microphone echo adjustment. Press Echo – to decrease microphone echo,
press Echo+ to increase microphone echo.
MUSIC PLAYBACK MODES
Press the mode button on the speaker or the remote to change between the different music
playback modes on the speaker.
Aux in:
Connect the included aux in lead to the aux in ports (red and white) on rear of the speaker and
connect the other end of the aux in lead to the earphone socket of your device (e.g.: MP3 player,
smart phone or CD player with an earphone jack). Begin music playback on your device. The sound
will come through the speaker.
Use the included AUX in lead with red and white ends to connect the sound from a DVD player or TV
into the aux in port on the front of the speaker. It is recommended that the sound source has DTS or
AC-3.
Alternatively, you can also use an aux lead with one connection going into the aux in port at the
front of the speaker and into your aux in device. The aux in lead with one connection on each end is
not included.
FM radio:
Scan in FM radio stations:
Press the scan button on the remote control. The speaker will then search for local radio stations
and scan them into the radio. They will be saved into pre-set memory positions. For better radio
reception, hold the wire FM antenna at the rear of the speaker in an upwards position and tape it to
a wall.