Installation - Lenoxx BT9350 Instructions Manual

Led stage lights bluetooth speaker
Hide thumbs Also See for BT9350:
Table of Contents

Advertisement

• If the power cord is damaged, do not use the equipment. The cord must be replaced by the
manufacturer or similarly qualified personnel to avoid a hazard. Contact the after-sales support line
for advice.
CAUTION:
To reduce the risk of fire or electric shock, do not expose this equipment, the cord or plug to rain or
moisture; do not use it anywhere near water or where water splashes or drips; do not touch the plug
with wet hands.
In the event of water or other liquids entering the device, unplug it immediately and clean and dry it
as best as possible. Then have it checked for damage by a qualified technician or contact the after-
sales support line.
• Do not repair the unit yourself. Only have it serviced by qualified personnel. Contact the after-sales
support line for advice.
• Unplug the unit from the power outlet after use to avoid possible damage during electrical storms,
or when the equipment will be unattended or unused for an extended period.
• Do not let the cord hang over the edge of a table or counter or touch any hot surface. Do not allow
anything to rest on or roll over the power cord and run any cords so that no one steps on or trips
over them.
• Do not run the cord near heat-producing appliances such as radiators, stoves or irons. Excessive
heat could melt insulation and expose live wires.
• Always grasp the plug, not the cord, when disconnecting the unit. Pulling the cord can damage the
internal wires and may cause a fire.

Installation

When installing the unit, make sure to place it:
• Away from heat sources, radiators or other products that produce heat.
• Away from areas with hot temperatures, high humidity or direct sunlight.
• Away from excess dirt and dust.
• Away from open windows and any place where water may get into the unit and damage it.
• Make sure there is free circulation of air around the unit. Do not place it on a thick carpet, a bed or
any place where ventilation holes are obstructed. Leave at least 10cm clearance around the unit.
• Make sure the mains socket is readily accessible at all times.
Usage conditions and restrictions
• Do not place heavy objects on top of the equipment or step on it.
• Do not place objects filled with water (such as vases) or any naked flame sources (such as lit
candles, incense sticks or cigarettes) on top of the unit.
• The equipment is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the equipment by a person responsible for their safety.
• Young children should be supervised to ensure they do not play with the equipment. Close
supervision is always necessary when an appliance is used by or near children.
• We assume no liability for any damage caused by noncompliance with these instructions or any
other improper use or mishandling of the equipment.
Getting Started
Before First Use
• The unit may become hot during operation. Always leave sufficient space around the unit for
ventilation.
• The voltage supplied to the unit should match the voltage that is printed on the back panel. If you
have any doubts concerning this matter, consult an electrician.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents