Related Manuals for Lenoxx BT9350
Summary of Contents for Lenoxx BT9350
- Page 1 Model no: BT9350 Batch no: PR3704 PLEASE READ AND RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
- Page 2 Product Introduction Get right into the groove with our LED Stage Lights Bluetooth Speaker, featuring flashing LEDs in the dual woofers and rotational stage lights. This Bluetooth system will be sure to put on quite a disco show in your very own lounge room. Each woofer is 15.4cm in circumference and puts out 40 watts, ready to gear your next party.
-
Page 3: Installation
• If the power cord is damaged, do not use the equipment. The cord must be replaced by the manufacturer or similarly qualified personnel to avoid a hazard. Contact the after-sales support line for advice. CAUTION: To reduce the risk of fire or electric shock, do not expose this equipment, the cord or plug to rain or moisture;... -
Page 4: Front Panel
• Avoid placing the unit in direct sunlight or close to any sources of heat. Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture. • Do not expose the unit to water. • Do not place the unit on an amplifier or receiver. •... -
Page 5: Remote Control
5. Mode: Press this button to change between the different modes on the speaker, Bluetooth, Aux in or FM radio modes. 6. Light on/off: Press to turn all the lights off. Press again to turn all the lights on. 7. Power standby: Press to put the speaker in standby mode. Press again to take it off standby mode. - Page 6 3. Numerical buttons: When the FM radio stations have been scanned in to the speaker, press the numerical buttons to go to a saved radio station position. 4. Lights: Press for all lights to be on or off. 5. LED: Press to change the mode of the lights displayed. 6.
-
Page 7: Bass And Treble
Bluetooth: Open the Bluetooth settings on your Bluetooth device (e.g.: smart phone). Look for the Bluetooth name BT9350 and pair. Begin music playback from the Bluetooth device. USB: Add a USB stick to the USB port. The speaker will detect that a USB stick has been added and will begin music playback from it. -
Page 8: Troubleshooting
TROUBLESHOOTING PROBLEM SOLUTION No sound Ensure the music source (e.g.: aux in device, Bluetooth device) is in music playback mode. Ensure you have turned the volume control knob on the top of the speaker. Remote control not working Replace the batteries in case of low power. The speaker is blocked by a large object, remove the large object.