Driving - Ford Cargo 2017 Owner's Manual

Before taking off:
Check the air pressures on the brake circuits.
Starting the engine
Turn the ignition on.
• Turn the ignition switch to position
until the engine warning lamp is turned off.
refer to maintenance and service chapter
MIL lamp
• When gear idle , (press clutch for manuel
transmission vehicles) and. Start the engine
by turning the ignition switch to position
(max. 10 seconds)
• Wait for 15 seconds if the engine does not
start and repeat the same procedure in the
same order.
112
OPERATION
Wait for the period determined by the
electronic control unit (10 to 40 seconds)
before starting again after a start failure. Do
not attempt to start in this period.
Cold Start
• Turn the ignition on. (position
starting lamp will be continuously on
• Start the engine (position
start lamp turns off,
- We advise you to apply the clutch pedal to
lower the load on the engine.
2 Wait
• If the engine does not start, switch the
ignition off, wait for 1 minute and repeat the
steps above.
3

Driving

CAUTION
4
2 ). Cold
3 ) when the cold