Connecting The System Control Box To The Floor Base - ViewSonic LD163-181 User Manual

Connecting the System Control Box to the Floor Base

1. Carefully unfold the System Control Box panel. Ensure the main system control
board is on the left.
NOTE: Use caution as the System Control Box panel will be separated into two
pieces, however the wires are connected.
2. Align the System Control Box to the eight (8) holes on the Bottom Cross Beam and
secure it with eight (8) screws (M6x10mm).
3. Install two (2) additional screws (M6x10mm) to connect the two halves of the
System Control Box.
29