Attaching Miter Lock Knob; Assembling Dust Elbow & Dust Bag - Bosch 4212L Operating/Safety Instructions Manual

Attaching Miter Lock Knob

Locate the miter gauge lock knob from among the
loose parts, and thread shaft into miter detent assem-
bly as shown in illustration.
Assembling Dust Elbow
And Dust Bag
1. With the miter arm locked in the down position,
push the dust elbow onto the dust port. Push the
dust bag onto the elbow and rotate both to desired
position.
2. Position dust chute/bag so that it does not interfere
with the tool during the cutting operation for all
miter/bevel settings.
3. The dust bag requires emptying when full of
sawdust. Empty it frequently and after completion
of sawing. Carefully remove dust bag from dust
elbow. Empty dust
bin by unzipping the bag. Be extremely careful of
dust disposed, materials in fine particle form may
be explosive. Do not throw sawdust on an open
fire. Spontaneous combustion, may in time,
result from mixture of oil or water with dust
particles.
DUST PORT – The dust port can accommodate the
dust chute and dust bag or optional VAC004 Vacuum
Hose Adapter, which accepts Bosch 35mm hoses.
When sawing chemically pressure
WARNING
!
treated lumber, paint that may be
lead based, or any other materials that may contain
carcinogens, use special precautions. A suitable res-
pirator must be worn by all personnel entering the
work area. Work area should be sealed by plastic
sheeting and persons not protected should be kept
out until work area is thoroughly cleaned.
Assembly
bag in proper trash
(continued)
Miter Gauge
Lock Knob
Shaft
Figure: Miter Lock Knob
Dust Bag
Figure: Dust Elbow and Dust Bag
12.
Dust
Port
Dust
Elbow