Set Up Touch on Your Projector
Usage Notice
Please follow all warnings, precautions and
maintenance as recommended in this user's
manual.
WARNING: Do not disassemble Touch
Unit.
WARNING: Do not use, store, or leave the
Touch Unit near fire, or in places with a
high temperature, e.g., in direct sunlight,
or in sun-heated cars.
WARNING: Use standard USB cable
(maximum length: 0.2 inch (5 m )). To
extend USB cable length over 5m, a
certified active extension USB cable is
required.
WARNING: Do not allow liquids or foreign
materials enter the Touch Unit.
Precautions
The Infrared (IR) camera on the projector
receives infrared signal from the Touch Unit
which is attached to the whiteboard.
To operate normally:
• The IR camera should face the
projected image area on the wall.
• Remove any obstacle in between IR
camera and Touch Unit.
• Do not place other infrared
communication devices, such as IR
microphone; lighting equipments; or
residential heating equipments etc,
nearby.
• Use only the interactive cable from the
accessory kit, with the L side connector
plugged into the Touch Unit.
Maintenance: Gently clean the optical port with
a dust blower.
Set Up Touch on Your Projector
3