Table of Contents
Advertisement
1-5-3. E:62:12 [Shift Lens Overheating (Yaw)] Occurred
Connect by the SeusEX and perform the following process.
Order
Block
Page
1
11
80
2
11
8E
3
11
8E
4
11
8E
5
11
8E
6
11
8E
7
11
8E
8
11
80
9
10
11
12
13
14
Note 1: Finish this operation within 10 seconds. If it is likely to take more than 10 seconds, set block: 11, page: 8E, address: F949, data: 00, and then retry.
Note 2: When the lens block was replaced, execute the necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the handheld operation.
1-5-4. E:62:20 [Abnormality of Thermistor] Occurred
Order
1
Turn the power ON
Confirm the connections of fkexible flat cables and connectors between the lens block and LD-233 board, LD-233 board and
2
VC-521 board.
In case of no malfunction of connections, replace the lens block with new one (Note). When the error has occurred in spite of the
3
lens replacement, replace LD-233 board with new one.
Note: When the lens block was replaced, execute the necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the handheld operation.
DCR-DVD510E/DVD910/DVD910E/
HDR-UX9E/UX10/UX10E/UX19E/UX20/UX20E_L2
Address
Data
7430
01
Write the data. (After it starts, set it before caution is displayed.)
F947
F0
Write the data.
F949
01
Write the data. (Note 1)
F949
00
Write the data.
F947
10
Write the data.
F949
01
Write the data. (Note 1)
F949
00
Write the data.
7430
00
Write the data.
Check if the shift lens moves while setting the order 2 to 7. If the shift lens does not move,
replace the lens block (Note 2). When the shift lens moved, proceed to the order 10.
While setting the order 2 to 7, measure with an oscilloscope the output voltage of R5534 in
the periphery of IC5501 on the LD-233 board to check the output voltage varies.
If the output voltage does not vary, replace the lens block (Note 2). When the output voltage
varied, proceed to the order 12.
Turn the power OFF.
While measuring with an oscilloscope the output voltage of R5549 in the periphery of IC5501
on the LD-233 board, turn the power ON to check that the output voltage immediately after
the power on change as shown in Fig. 2.
If the output voltage change as shown in Fig. 2, replace the lens block (Note 2). If it does not
change as shown in Fig. 2, inspect the camera control circuit (IC1301 of VC-521 board) periphery.
Procedure
Procedure
1-6
ENGLISH
JAPANESE
ENGLISH
JAPANESE
Advertisement
Table of Contents
