Download Print this page
White Rodgers 37C73U Installation Instructions

White Rodgers 37C73U Installation Instructions

Water heater thermostat control

Advertisement

Quick Links

WHITE-RODGERS
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
Fixed Adjustment Main and Pilot Regulators
The main and pilot gas regulators require no field
service. They automatically control and maintain the
outlet main and pilot burner gas pressure.
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS BEFORE INSTALLING OR OPERATING THIS
CONTROL COULD CAUSE PROPERTY DAMAGE, PERSONAL INJURY AND/OR DEATH.
1. This control must be installed or serviced only by a
professional.
2. Do not use force when moving the gas control knob. If
you cannot turn the knob with hand pressure only, the
control must be replaced.
3. Do not use the control if the knob will not "pop up" after
being depressed while the knob is in the PILOT posi-
tion. The mechanism is damaged and the control must
be replaced. Shut off gas to the water heater.
4. For your safety, this control is supplied with tamper
resistant screws. Do not attempt to repair or adjust the
control. If you experience problems, replace the control
immediately. Continuing to use a damaged control
could result in fire and/or explosion.
5. An odorant has been added to the gas to help you
detect it. Before lighting, search for the odor of gas by
sniffing at floor level around the water heater.
WHITE-RODGERS DIVISION
EMERSON ELECTRIC CO.
9797 REAVIS ROAD
ST. LOUIS, MISSOURI 63123-5398
Water Heater Thermostat Control
FOR NATURAL GAS ONLY
"WHAT TO DO IF YOU SMELL GAS"
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
Do not use this Natural Gas control on a LP Gas
water heater. Improper operation could occur, re-
sulting in personal injury and/or death due to Car-
bon Monoxide poisoning, fire, or explosion. Check
for proper gas type as listed on the rating plate
affixed to the water heater.
6.
In some situations, the gas may lose its odor. To detect
unodorized gas, you must have a gas detector which
can be purchased from your gas company. If you do not
have a detector and have the slightest suspicion that
gas may be present, get out of the house and call the
gas company. DO NOT RELY TOTALLY ON YOUR
NOSE.
Scald burns occur in under one second with 160
water, which this thermostat will deliver if the
temperature dial is set at "VERY HOT". Lower
settings of the temperature dial will reduce the risk
of scald and will reduce your fuel bill.
Printed in U.S.A.
37C73U
Installation Instructions
FOR YOUR SAFETY
WARNING
!
WARNING
!
PART NO. 37-6092A
9912

Advertisement

loading

Summary of Contents for White Rodgers 37C73U

  • Page 1 WHITE-RODGERS DIVISION EMERSON ELECTRIC CO. 9797 REAVIS ROAD ST. LOUIS, MISSOURI 63123-5398 37C73U Water Heater Thermostat Control Installation Instructions FOR NATURAL GAS ONLY FOR YOUR SAFETY “WHAT TO DO IF YOU SMELL GAS”...
  • Page 2 INSTALLATION REPLACEMENT INFORMATION REMOVING OLD CONTROL 1. Shut off gas to water heater. 2. Shut off water at cold water inlet. 3. Connect hose to heater drain cock. Drain water to a nearby drain. Open a hot water faucet for faster drain- ing.
  • Page 3 8. BEFORE LIGHTING THE PILOT, CHECK THE GAS LINES FOR LEAKS: a. Use a soapy water solution. DO NOT test for gas leaks using a match or open flame. b. Brush the soapy water solution on all gas pipes, joints, and fittings. c.
  • Page 4: Temperature Regulation

    TEMPERATURE REGULATION After the gas connections are made, water is in the heater and the pilot light is ignited, the control must be set to the desired water temperature. The recommended water temperature dial setting is at the arrow ( ). The water temperature out of the heater at this setting will be approximately 120 F.