Update Procedure - Yamaha DSP5D Upgrade Manual

Update Procedure

The numbers below correspond to the DSP5D Loader step number.
1.
Press the POWER switch (A) of the DSP5D to turn it on. Click the [Next] button. The IN/OUT
[TX]/[RX] LEDs (B) light in succession from the left. Wait for about 30 seconds until all four LEDs go
into their normal lit state, then click the [Next] button.
2.
Click the [Next] button.
If you do not want to update the LCD CPU and update only the Main CPU, click the [Skip] button.
3.
Specify the following settings, then click the [Start] button to start the LCD CPU update. When the
update is complete, a "Complete" message appears. Click the [Close] button.
•
Input Port/Output Port: Select the input/output ports for communication between the DSP5D
and the computer. The port names set for the DME-N Network Driver are shown.
•
Load File: Confirm that the "V***_Update\Data\LCD" folder is selected as the location of the
LCD CPU firmware. If not, select the correct folder by clicking the [...] button.
DSP5D Upgrade Guide
3