Service Menus - Fostex PD-6 Service Manual

PD-6 Service Manual

4. SERVICE MENUS

Various Service menus in addition to the normal SETUP menus are
available on PD-6 in order to judge if the unit is working correctly.
4-1. Accessing to Service Menus
1) Power on PD-6.
2) While holding down the STOP key, press the SETUP key.
The Service menus are displayed in addition to the normal menus.
4-2. Software & Firmware Version
Although this is not a Service menu, the PD-6 MAIN software
version as well as the DVD-RAM drive firmware version can be
confirmed. To check, select the "Version" menu and press the
ENTER knob.
There are three versions displayed in the "Version" menu.
The top one ("Ver1.02 14/MAY/'03" on the right example) is the
PD-6 MAIN software version number. The middle one
("K0B1.04.05.REV" on the right example) and the bottom one
("K00B.02.15REV on the right example) indicate the DVD-RAM
drive firmware version number.
If the new MAIN software and / or the DVD-RAM drive firmware
are sent from us, check the version number in this menu after updating
the software / firmware.
4-3. Reset setup memory
This menu is used for resetting various parameters in the SETUP
menus to the default value such as "Ref.level" to "-20dB" and "Peak
hold" to "3sec". Also executing the MEMORY RESET is nececsary
after updating the MAIN software.
To reset the setup memory, select the "Reset setup memory" Service
menu and press the ENTER knob. Then, while "SURE?" is flashing,
press the ENTER knob again. After the "Completed!" message
appears for a short while, the LCD returns to the SETUP / SERVICE
menu select display.
CAUTION:
Every time the MAIN software is updated, execute the "Reset setup
memory".
14
MAIN software version
and programming date
DVD-RAM drive firmware version
and programming date