Advertisement
Brought to you by Augusta Flint
Operation
Note: The Pipe Bender is designed to bend water pipe and heavy gauge galvanized pipe
used in commercial applications. When bending conduit or thin walled pipe, you may experi-
ence problems with kinks or creases. To help limit the problem, fill the pipe with sand and cap
both ends, before bending.
Set Up.
1. Place the Pipe Bender on a solid, flat, level workbench. Pipe Bender must always be
clamped or bolted down to the workbench.
2. Select the Bending Die (#7 thru #12) that matches the size of pipe you want to bend.
Each Die is stamped with the size.
3. Place the Bending Die (#7 thru #12) onto the 12 Ton Bottle Jack (#2). See Figure 1 and
Assembly Drawing on page 8.
Figure 1
Roller Shaft (#4
)
Bending Die (#7 thru#12)
Frame (#1)
12 Ton Bottle Jack (#2)
Page 4
SKU 38024
38024.p65
4
10/30/03, 10:48 AM
Advertisement
