Brought to you by Augusta Flint Specifications Jack Weight Capacity 12 Tons Pipe Bending Diameter Range 1/2”, 3/4”, 1”, 1-1/4”, 1-1/2”, 2” Max. Degree of Bend 90 Degrees Ram Diameter 1.690” Max. Ram Travel 9.5” Dimensions (w/o handle) 24” x 4.25” x 21.5” Weight 87.5 Lbs.
Page 3
Unpacking When unpacking, check to make sure the parts listed on page 7 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Brought to you by Augusta Flint Operation Note: The Pipe Bender is designed to bend water pipe and heavy gauge galvanized pipe used in commercial applications. When bending conduit or thin walled pipe, you may experi- ence problems with kinks or creases. To help limit the problem, fill the pipe with sand and cap both ends, before bending.
Page 5
Brought to you by Augusta Flint Operation (continued) For steps 4 through 8, refer to Figure 2 below, and Assembly Drawing on page 8. 4. Depending on the size of the pipe you wish to bend, the Rollers (#5) might need adjust- ment.
Brought to you by Augusta Flint Maintenance Note: The 12 Ton Bottle Jack (#2) should last for several years of use. The only parts that eventually wear out, are the seals. If you notice hydraulic fluid leaking from the telescoping shaft (Ram) of the Jack, you need to install a Seal Kit.
Page 7
Brought to you by Augusta Flint Parts List for Pipe Bender Description Qty. Frame 12 Ton Bottle Jack Hex Bolt Roller Shaft Roller Hitch Pin 1/2” Bending Die 3/4” Bending Die 1” Bending Die 1-1/4” Bending Die 1-1/2” Bending Die 2”...
Page 8
Brought to you by Augusta Flint Assembly Drawing for Pipe Bender Page 8 SKU 38024 38024.p65 10/30/03, 10:48 AM...
Page 9
Brought to you by Augusta Flint Parts List for Jack Page 9 SKU 38024 38024.p65 10/30/03, 10:48 AM...
Page 10
Brought to you by Augusta Flint Diagram Assembly Drawing for Jack Page 10 SKU 38024 38024.p65 10/30/03, 10:48 AM...