Samsung OfficeServ 7400 Technical Manual page 38

OfficeServ 7400
TECHNICAL MANUAL
TEPRI2 CARD
The TEPRI2 card is a DUAL circuit digital trunk interface that supports either T1 or ISDN
PRI service. It also supports Q-Sig/PRI signaling required for networking multiple
systems. This card is functionally identical to the TEPRIA card however it offers two
independent circuit interfaces labeled P1 and P2 on the front panel. The TEPRIA offers
only a single circuit.
SPECIFICATIONS
• In order to use both circuits of the TEPRI2, it must be installed in the MAIN cabinet.
If the TEPRI2 is installed in an OS7400 expansion cabinet, only the first circuit can
be used. The second circuit will be disabled.
• The TEPRI2 CANNOT be used in an OS7200 expansion cabinet.
• BOTH circuits P1 and P2 must be used for the same function: either both are
TELCO interfaces OR both are used for QSIG PRI networking. One cannot be used
for Telco, while the second interface is used for Qsig/PRI networking.
• Add as many TEPRI2 cards as needed.
Set S2 and S3 switches and jumpers of the TEPRI2 module as follows:
1
1
J2
J1
1
J4
J3
Figure 3.20 Setting Switches and Jumpers of the TEPRI2 Module
1
3.23
Table of Contents
Home Page
INSTALLATION
PART 3 JUNE 2006
ON
4
1
OFF
S2
4
1
S3