Sub-Zero 315I Service Manual
Uc ice maker
Hide thumbs
Also See for 315I:
- Technical service and parts manual (66 pages) ,
- Planning information (5 pages) ,
- Specifications (5 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Sub-Zero 315I
Summary of Contents for Sub-Zero 315I
- Page 1 subzero.com 800.222.7820 Service Manual Installation Information...
-
Page 2: Installation Information
Other The model 315I uses a fan to take in room air through impurities are chemically bonded to the water mole- the front right side of the kickplate/grille and discharge cules, referred to as dissolved solids, and cannot be fil- warm air out the left side of the kickplate/grille. -
Page 3: Electric Shock Hazard
Drain There are two 315I models with different drainage con- figurations, the model 315I and model 315IP: The model 315I is a gravity drain model that requires a 1/8" 15" 1/8" drain tube that is pitched down from the outlet at the... - Page 4 Leveling (Model 315I & 315IP) Note: The unit must be leveled prior to installation. There are four leveler legs on a model 315I, one at each corner. To level the unit, turn the leveler legs counterclockwise to raise the unit or clockwise to lower...
- Page 5 Check for leaks. 13. Replace all parts removed in step 2. Securing the Unit (Model 315I & 315IP) Once the icemaker is installed, secure the unit to the cabinet by inserting two #8 x 1/2” flat head screws (sup- plied with the unit) through the holes in the flange of each hinge.
- Page 6 Figure 2-6. Kickplate/Grille Adjustment Door Reversing Door Swing Mounting Screws All model 315I units are manufactured with the hinges Upper on the right side of the door. The door and hinges are Door designed to be reversible, so that the hinges can be Panel moved to the left side of the door.
- Page 7 Installation Information Model 315I (UC Ice Maker) Stainless Steel Door Panels Stainless steel door panels are available from local When the reveal on the hinge side of the door panel is Sub-Zero distributors/dealers. There are two sizes: less than 1/4”, use caution when closing the door as •...
- Page 8 Certain installations may require the door of the model upper and lower hinge covers, then adhere covers 315I to stop at 90° instead of the full 115°. A 90° door to top and bottom of each hinge bracket as shown stop pin is supplied with the unit.
- Page 9 Installation Information Model 315I (UC Ice Maker) Initial Start-Up When the installation is complete and all electrical and water hook-ups have been checked, be sure to remove all tape and packing materials before initial start-up. Follow the instructions below for initial start-up: 1.