Section 7: Lubrication - White Outdoor Z - 165 Operator's Manual

16. Remove quarter inch by seven inch pins from top and bottom holes.
17. Set parking brake and start the engine (set throttle at full speed). Make sure that the PTO is off.
18. Rotate rods (lengthen or shorten) to bring each hydrostat to neutral.
NOTE:
The control linkage going to the hydrostatic pump has left-hand threads at the pump and right-hand
threads at the tower.
19. Tighten the jam nuts earlier loosened.
20. Reassemble safety switches.
21. Reassemble body panels.
22. Reassemble drive handle assembly.
23. Make sure that all hardware is tightened.

SECTION 7: LUBRICATION

Use the two tables that follow for lubrication details. The first table is for oil details and the second table is for
grease point information.
Oil
Engine crankcase
Hydraulic units
Grease Point
Caster Ass'y - 3 fittings (1 on each
wheel spindle and one on middle of
caster assembly)
Caster wheels - 2 fittings (1 on each
wheel)
Control Tower - 2 fittings
(Right side of tower)
Deck Lift Pivot
Lift Handle
Mower Deck
Check Change
See Engine Operator's Manual Section
50 Hours 500 Hours
When to Grease Type of Grease
50 Hours
50 Hours
50 Hours
50 Hours
50 Hours
50 Hours
Capacity Type
9.5 Quarts Part Number 737-0305 (10W40 motor oil)
Two strokes (minimum) of lubricator using 251 H EP grease or
equivalent No. 2 multipurpose lithium grease (refer to SECTION
8: MAINTENANCE on page 21 for locations)
Two strokes (minimum) of lubricator using 251 H EP grease or
equivalent No. 2 multipurpose lithium grease (refer to SECTION
8: MAINTENANCE on page 21 for locations)
Two strokes (minimum) of lubricator using 251 H EP grease or
equivalent No. 2 multipurpose lithium grease (refer to SECTION
8: MAINTENANCE on page 21 for locations)
Two strokes (minimum) of lubricator using 251 H EP grease or
equivalent No. 2 multipurpose lithium grease (refer to SECTION
8: MAINTENANCE on page 21 for locations)
Two strokes (minimum) of lubricator using 251 H EP grease or
equivalent No. 2 multipurpose lithium grease (refer to SECTION
8: MAINTENANCE on page 21 for locations)
Two strokes (minimum) of lubricator using 251 H EP grease or
equivalent No. 2 multipurpose lithium grease (refer to SECTION
8: MAINTENANCE on page 21 for locations)
19