Table of Contents
Advertisement
Step 2
Install
Anti-Tip
Brackets
• Mount brackets provided using #12 or #14 wood
• Screws must be driven at least one inch into vertical
• Attach a 71" long 2x4 block to brackets as shown.
Roll Both Products into Opening
• Gently push each product into opening with hands
Step 3
Both products MUST BE LEVEL AND PLUMB with each
Level Both
other and adjacent cabinetry on each side. Toekick
Products
heights should align with cabinetry.
• Adjust carefully. Both models have 4-point leveling.
• Raise units to the same level, aligning with adjacent
• Adjust rear wheels beneath the product to just barely
• Turn the 7/16" hex nut located above the front wheels
• To adjust the front leveling legs: Use a 1/4" angled
Step 4
Note: This step can be used
Secure
as an alternative to Step 2,
Products
Anti-Tip bracket installation,
To Sides
whenever brackets cannot
be used. Whenever
possible, perform this step
for additional anti-tip
security.
When using 1/2" to 3/4" thick side panels, the front
flange of the case trim is attached to the side panel.
• Open door to access case trim.
• Drill hole in trim slightly below the interior opening.
• Drive screw through the trim and into the side panel.
• Follow the same procedure on the opposite outside
16
CAUTION
WARNING
ANTI-TIP PRECAUTIONS
These products are heavy at the top and must be
secured to prevent the possibility of tipping over.
ATTENTION
PRECAUTIONS CONTRE LES BASCULEMENTS
Le réfrigérateur est beaucoup plus lourd en haut et
il faut le maintenir en place pour éviter la
possibilité de son basculement vers l'avant.
screws located 83-1/2" from the finished floor.
wall studs.
against front corners. Push back into the opening until
it is flush or semi-flush with adjacent cabinets.
The front is supported by leveling legs, the rear is
supported by wheels.
toekick heights.
touch the 2x4 block.
to raise or lower the back of the refrigerator.
wrench to turn the top of the leveling leg, or, turn the
bottom of the legs with a 1-1/2" wrench.
product trim.
ZUGSS Trim Kit
Unified Stainless Steel Grille Panel
Block
Side View
83-1/2" From Floor
Important Note: When the products are installed under
a soffit or if there is not enough height for this method
of security, use Step 4 as an alternative. The refrigera-
tor and freezer must be secured to prevent tipping.
Hex Nut Adjusts
Rear Wheels
Units must be 1" apart and evenly aligned at top and
bottom. The inside case trims must align, top and
bottom.
Stud
OR
If the product is installed between cabinets with no
side panels or into a custom enclosure, install a spacer
block as shown.
Soffit
83-1/2"
From
Floor
to
Bottom
of Wood
Block
Side View
Mounting Bracket
2 x 4 Cut
To 71"
Length
Wood Screws Mounted into
Vertical Wood Studs
Leveling Leg
Refrigerator
Cabinet
Door
Spacer
Block
Advertisement
Table of Contents
