Table of Contents
Advertisement
Step 5
These products have a 4-point leveling system. The
Level
front is supported by leveling legs, the rear is
Refrigerator
supported by wheels.
• Adjust rear wheels beneath the product to just
• Turn the 7/16" hex nut located above the front
• For front leveling legs, use a 1-1/2" open-end
• Adjust carefully, the product should be level and
Step 6
Secure
Product
Note: Whenever possible,
to Sides
perform this step for additional
anti-tip security. This step can be
used as an alternate to Step 4,
Anti-Tip bracket installation,
whenever brackets cannot be
used.
When using 1/2" to 3/4" side panels, the front flange of
the case trim is attached to the side panel.
• Open door to access case trim.
• Drill hole in trim below interior opening. Drive screw
• Follow the same procedure on opposite side.
Step 7
Check to be sure that power cord is not plugged into the
Connect
wall outlet.
Freezer
Water
• Locate and bring copper tubing to the front of the
Supply
• The copper tubing should be just long enough to reach
• Slip a 1/4-1/4 union nut (provided) over both ends of the
• Turn on the water to check for leaks.
barely touch the 2x4 block.
wheels. Turn to raise or lower.
wrench.
plumb with cabinetry, and should align with toekick
height.
through trim and side panel.
cabinet.
the coupling. Excess tubing length could interfere with
door closing or toekick installation.
copper tubing at the left front leg of the freezer and
couple the lines.
Installation
36" Stainless Steel Refrigerators, Freezers
Hex Nut Adjusts
Rear Wheels
Stud
OR
If installed between cabinets with no side panels or in a
custom enclosure, install a spacer block as shown.
• Open door to access case trim.
• Drill hole in trim below opening. Drive screw through
trim and into block.
• Follow the same procedure on opposite side.
Leveling Leg
Refrigerator
Cabinet
Door
Spacer
Block
11
Advertisement
Table of Contents
