Package Contents; Electrical Safety; Voltage Drops - DeWalt D28715 Original Instructions Manual

Package Contents

The package contains:
1 Chopsaw
1 Cutting disc
1 Hex key
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1, 7)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
INTENDED USE
Your D28715 chop saw has been designed for the
cutting of variously shaped steel materials.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
The D28715 chop saw is a professional power tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
a. Lock pin
b. Spark deflector screw
c. Spark deflector
d. Base
e. Fence
f. Vise
g. 8mm hex wrench
h. Crank
i Vise lever
j. Wheel
k. Spark guard
l. Wheel lock lever
m. Trigger switch
n Padlock hole
o. Extra blade bolt
p. Extra blade bolt washer
q. Quick-Change blade clamp (fig. 7)

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your tool is double insulated in
accordance with EN 61029;
therefore no earth wire is required.
WARNING: 115 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
In case of cord replacement the tool must only
be repaired by an authorized service agent or by
qualified electrician.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data).
The minimum conductor size is 1.5 mm
using a cable reel, always unwind the cable
completely.
Connecting to the Mains
The mains supply to be used for this machine must
be equipped with a 16 A cut-out fuse with time delay.

Voltage Drops

In rush currents cause short-time voltage drops.
Under unfavourable power supply conditions,
other equipment may be affected. If the system
impedance of the power supply is lower than
0.25 , disturbances are unlikely to occur.
EN GL IS H
. When
2
29