Power Supply Connection (Locker Controller With Distribution Board) - Metra Electronics ELS NET LC16ANT Technical Manual

 Power supply connection (Locker Controller with distribution board)
Regulated 12 VDC power supply is required for proper operation. Connect as many units as possible
to a single power supply unit. Consult the Technical Specifications section of this document for
current consumption.
Connect 12V DC regulated power supply to designated terminals. The terminals are marked as
for positive connection and
 WARNING
 Mind the polarity! Wrong polarity could result in irreparable damage to the device.
 Respect power requirements data! Using unsuitable power supply could result in damage to the
power supply and to the device.
GND for ground connection.
Page 9
Locker Controller ELS NET Technical Manual
+12V