Table of Contents
Advertisement
Locker Controller ELS NET Technical Manual
*NOTE:
Local CAN connectors
and
are internally parallel connected.
**NOTE:
Local CAN connectors
and
are internally parallel connected.
***NOTE:
Local CAN connectors
and
are internally parallel connected.
****NOTE:
12V DC Power connectors
and
are internally parallel connected.
Connecting Locker Extension Modules
When Locker Controller without mounting plate is used connect up to two Extension modules by 6
wire flat cable. There are two equivalent connectors on the main electronics board (LC16A) use the
one which suits your connection best.
When Locker Controller is ordered with mounting plate Extension Modules (LC24_* and LC32_*) are
already connected.
Locker Extension Module setting
The first Locker Extension Module DIP switch (indexes 17-24) and second Locker Extension Module
DIP switch (indexes 25-32) must be set as follows:
Page 7
Advertisement
Table of Contents
