Table of Contents
Advertisement
Test mode activation
STEP 2:
Connect the ELS NET Tester to the Locker Controller as described in the paragraph "ELS NET
Tester connection".
STEP 3:
Power-off and back on the Locker Controller to activate the Test mode.
NOTE:
To return to Normal mode of operation set the switches 1 to 4 back to OFF (switch down) and
power-off and back on the Locker Controller.
Erasing operating parameters
Operating parameters can be erased (initialized to default values) only in Test mode of operation.
Locker Controller ELS NET Technical Manual
STEP 1:
With small flat headed screwdriver or similar tool
set switches 1 to 4 located on the "Operating mode DIP
switch" to ON (switch up).
STEP 4:
Shortly after power on, numbers from "0.0.0.0."
to "9.9.9.9." are displayed. This indicates that the Test
mode of operation is activated.
STEP 1:
Before powering-up the Locker Controller in Test
mode,
both
pushbuttons
Parameters request) should be pressed and hold for 3
seconds after power up.
Operating parameters are erased.
Upon buttons release, Test mode of operation is
activated.
Page 18
(Emergency open and
Advertisement
Table of Contents
