Warranty - Whirlpool System I Instructions Manual

Whirlpool undercounter water filtration systems i, ii, & iii instructions
Table of Contents

Advertisement

Performance Data Sheet
This product has been tested and listed by NSF International
under Standard 42
for Taste, Odor and Chlorine reduction (Class I) and Particulate reduction (Class
II) and under Standard 53 for Cyst, Turbidity, Lead and VOC reduction.
Whirlpool Water Filtration System Ill
SPECIFICATIONS:
Lead, VOC and Taste/Odor/Chlorine
reduction (Class I)
CAPACITY:
500 Gallons
SERVICE FLOW RATE:
0.6 GPM (2.2 Umin) @ 60 psi
General
Performance
Chlorine1
Average
lnfluent
2.0 mg/L
Maximum
Minimum%
NSF Test
Effluent
Reduction
Requirement
co.1 ?glL
92%
minimum75%
reduction IClass I)
Particulate
560,000 part/ml2
18,000 parVmL
98%
minimbm 85%
reduction (Class II)
cyst
215,000 4-6 p/mL3
390 4-6 u/mL
99.9%
minimum 99.9%
reduction
Turbidity
14 NTU
0.42 NTU
97%
minimum effluent
1 .O NTU
Contaminant
Reduction
U.itfA
Average
Maximum
Minimum%
NSF Test
Performance4
lnfluent
Effluent
Reduction
Requirement
Lead @ pH 6.5
0.015 mg/L
0.16 mg/L5
I
I
0.005 mg/L
97%
maximum effluent
0.015 ma/L
Lead @ pH 8.5
0.015 mg/L
0.17 mg/L5
0.002 mg/L
99%
maximum effluent
0.015 mg/L
'Free Available
Chlorine.
Test
requirement
is at leas.1 10,000 ParticletimL
of AC Fine Test Dust.
3Tes.l reouirement
is 4-6 micrometer
size particles
per mL of influent.
'These
&taminants
are not necessarily
in your w&r
supply.
Perlormance
may vary based on local water conditions.
5Test requirement
0.15 rn@
15%.
VOLATILE ORGANIC CHEMICAL REDUCTION
This system has met the testing requirements
of Standard 53, Section 5.1.1 for the
reduction of chloroform,
which is the surrogate for the following chemicals
Maximum
lnfluent
Mlnimum
Occurrence
Effluent
Concentration
Percent
Chemical
Levels (ppb)
Level (ppb)
Other VOc's'
Reduction
Benzene
30'
;:
cis-1,3-Dichloropropene
'PBpob'
95%
Carbon Tetrachtortde
40'
Chlorobenzene
80
95%
p-Dichlorobenzene
80'
$
Hexachlorobutadiene
40
95%
Trichloroethylene
300'
ortho-Xylene
80
95%
Trihalomethanes
300
15
trans-1 ,P-Dichloroethene
80
95%
(surrogate chemical)
1 ,1,2,2-Tetrachloroethane
80
95%
1, 1 -Dichloroethylene
50'
g:
1,2-Dichlorobenzene
80
95%
1 ,l ,l -Trichloroethane
80'
1 ,P-Dichloroethane
80
95%
1 ,P-Dichloroethane
100'
Ethylbenzene
802
2:
Tetrachloroethylene
802
Toluene
802
;:
1 ,P-Dichloropropane
80'
53
'Influent
levels are the 95th percentile,
occu~ence
levels are per Federal
Reg~sler, Vol. 50, No. 219. November
13, 1965. p. 46917.
'Since the
s5m
percentile
ooxnence
levels were too low and thus were not pertinent
for testing lhess chemicals
against
their MCL's.
a reasomble
level was selected
for surrogate
tasting
as shown.
'EPA Primary
Maximum
Contaminant
Levels
'Maximum
eflluem
concentrations
set at the practical
quantitation
level (PQL) which is less than the MCL.
Systems I, II & Ill
APPLICATION GUIDELINESMATER SUPPLY PARAMETERS
Water
SUDDIV
- community or orivate well
Potable (suitable for drinking)
Water Pressure
30 -100 psi (207 - 690kPa)
I
Water Temperature
OH Ranoe
40" - 100°F (4.4" - 38°C)
1
6-9
Maximum TDS Level
I
500 ppm
I
I Dissolved Iron
I
c 0.1 ppm
I
Dissolved Manganese
< 0.05 ppm
Turbidity
< 1 NTU
Waier supplies
that exceed limits for iron or manganese
require
pretreatment.
It is essential
that operalional,
maintenance
and filter replacement
requirements
be carried
out for Ihe product
to perform
as advertised.
CAUTION:
Do Not use where water is microbiologically
unsaie
or with waler of unknown
quality
withour
adequate
disinlection
before or after the umt.
WARRANTY
Length of Warranty:
One Year Full Warranty
(From date of purchase)
Whirlpool will pay for:
Replacement
parts and repair labor to correct defects
in materials or workmanship
for the entire product
except for the filter cartridge(s).
Service must be
provided by an authorized Whirlpool servicing outlet.
Five Year Limited Warranty
(Second through fifth year
from date of purchase)
Whlrlpool will not pay for:
A. Service calls to:
Replacement
parts to correct defects in materials or
workmanship
for the entire product except for the
filter cartridge(s).
1.) Correct the installation
of the product.
System must be installed and operated in accor-
dance with Whirlpool procedures
and guidelines.
2.) Instruct you how to use the product.
3.) Correct house plumbing.
B. Repairs when product is used in other than normal, single-family
household
use.
C. Repairs when product is damaged from neglect, misuse, abuse, freezing or hot water, fouling
with sediment or scale, bacterial attack, alterations,
improper installation,
or installation
not in
accordance
with local plumbing codes.
D. Any labor costs during the limited warranty.
E. Replacement
parts or repair labor costs for units operated outside the U.S.
F. Pickup and delivery.
This product is designed to be repaired in the home.
G. Repairs to parts or systems caused by unauthorized
modifications
made to the product.
The performance
and functioning
of your water filtration system is directly related to the quality of
the water being treated and the particular application
in which it is used. Please consult "Water
Requirements"
and "Use 8 Care".
Whirlpool shall not be Ilable for lncldental or consequential damages.
Some states do not allow
the exclusion or limitation of incidental or consequential
damages, so this limitation or exclusion may
not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
9n the absence
oi offiially
stated occurrence
levels and MCCs.
tne surrogate
mfluents
were selected
to
provlae a
reasonaole
IesI.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

System iiSysterm iiiWsc300ywWsc100ywWsc200yw

Table of Contents