Channel Scan - Cobra microTALK MT 925 PRO Manual

MODE FUNCTIONS
To Recall a Stored Memory Channel
Location:
1. Press the MODE button until the Memory icon
and the memory location number (0 to 9) flash
on the display.
2. Press the CHANNEL UP or CHANNEL DOWN button to select a
memory location number (0 to 9).
NOTE: If a location has been programmed, its associated
channel/privacy code or channel/DCS code will be shown on
the display.
3. Press the ENTER button to return to LISTENING MODE on the
selected memory location.
NOTE: Pressing the MODE button will put you in "Program A
Memory Location".
NOTE: While recalling a stored memory location, if you do not press
any buttons for fifteen (15) seconds your radio will automatically return to
LISTENING MODE on the channel/privacy code or channel/DCS code displayed
before you entered Mode Functions.

Channel Scan

Your microTALK ® radio can automatically scan channels (1 to 8).
NOTE: The radio ignores specific CTCSS privacy codes and DCS codes
while scanning channels.
To Scan Channels:
1. Press the MODE button until the Scan icon and the channel number
flash on the display.
2. Press the CHANNEL UP or CHANNEL DOWN button to begin scanning
channels.
The Scan icon will continue to be displayed when Channel Scan is On.
Your radio will continue to scan all channels and stop if an incoming
transmission is detected. Your radio will remain on that channel for ten
(10) seconds.
While setting Channel Scan, if you do not press any buttons for fifteen
(15) seconds your radio will automatically return to LISTENING MODE
on the channel/privacy code or channel/DCS code displayed before
you entered Mode Functions.
During An Incoming Transmission,
You Can Choose From The Following:
a. Press and hold the TALK button to communicate on that channel. Your radio will
remain on that channel and return to LISTENING MODE.
b. Press the CHANNEL UP or CHANNEL DOWN button to resume scanning channels.
If you press the TALK button while scanning and not within ten (10) seconds of receiving a
transmission, you will transmit on the channel on which, during scanning, you last received
a transmission. This will return the radio to LISTENING MODE.
If you do not press any button within ten (10) seconds, your radio will automatically
resume scanning channels.
During Scanning (while not receiving a transmission),
You Can Choose From The Following:
a. Press and hold the TALK button to communicate on either the channel/privacy code
or channel/DCS code that was displayed before you entered Mode Functions or the
channel on which, during scanning, you last received a transmission. This will return
the radio to LISTENING MODE.
Mode Button Select Memory
Location
Channel Buttons
Enter Button
Scan Icon
Mode Button
Select Scan Channels
Channel Buttons
English